Paper coffee filters: what to check before brewing

By: ·

Before changing your grinder setting, check a simpler part of the setup: the paper filter. This guide helps you prepare for a manual pour-over and distinguish instructions for a particular brewer from general advice. It is not a filter test or a promise of better flavour. The aim is to know which paper you are using and what happens before the coffee goes in.

1. Match the paper to the brewer

Check the brewer model and the designation on the filter packet. HARIO sells size 01 paper for the V60 01; a similar cone shape alone does not establish compatibility. Keep the packet or take a label photo for your own reference. When buying a replacement, compare the full designation rather than choosing by paper colour alone. Avoid cutting an unrelated filter simply to make it fit inside the vessel.

2. Follow the folding instructions for your system

Open the filter according to its manufacturer's instructions. CHEMEX places the three-layer side against the spout, which also serves as an air channel. That is a rule for this system, not an instruction to fold every filter into three layers. Inspect the empty setup before adding coffee: the paper should not be torn and the brewer should sit securely on a suitable vessel.

3. Plan where rinse water will go

If the instructions or your chosen recipe include rinsing the paper, do it before adding ground coffee. Have somewhere to discard the rinse water and empty the receiving vessel before brewing. Do not accidentally leave it in the server, where it would become part of the later measurement. There is no single rinse volume prescribed here for every filter; keep your routine consistent when comparing successive cups.

4. Set up the measurement before you start

Once the filter is prepared, place the setup on the scale and record the coffee dose separately from brewing water. Tare at the point required by your recipe. A quick check — empty server, correct paper, stable vessel and recorded dose — helps keep the stages distinct. While pouring, stay below the filter edge and within the equipment's capacity; follow the brewer's instructions.

5. Keep a reference when changing paper

Treat a new filter type as one change in your setup. For the first attempt, keep the coffee, dose and pouring plan the same. Note the paper model and what you observe rather than immediately attributing every difference to one factor. If something fits poorly, check the designation and placement first. The public Crema pour-over recipe below provides a starting point; adapt it to your equipment and record the settings you actually use.

Full free recipe →

Sources

Crema — V60 · HARIO — V60 Paper Filter 01 · CHEMEX — Filter FAQ · App Store