A number beside a pouring step can mean the water to add now or the total reached so far. Those are different instructions. Before brewing, identify which convention the recipe uses. The small calculation below helps you read a schedule; it is not a new brewing recipe or a promise about flavour.
Label the numbers before heating water
Look for words such as “add”, “another”, “up to” and “total”. “Add 100 ml” describes an addition. “Pour to 150 ml total” describes the amount reached since the start, including earlier pours. If the wording is ambiguous, check the complete recipe or its author’s explanation. Do not decide by guessing from the largest number alone.
Count the bloom in the recipe water
Crema’s public V60 recipe uses 250 ml water in total. Its first wetting step uses 45 ml, explicitly included in that total. That leaves 205 ml for the remaining pouring. It does not mean 45 ml followed by another 250 ml. Water used only to rinse the filter is discarded before brewing and is not part of this brewing total.
Translate targets into additions
As an arithmetic exercise in millilitres, imagine cumulative targets of 45, 150 and 250. The additions would be 45, then 105, then 100 ml. Subtract the previous total from the next target. These middle targets illustrate the calculation; Crema’s recipe does not prescribe a separate 150 ml stage. Keep the recipe’s actual sequence and timing when brewing.
Keep the measuring unit visible
Write ml or g beside your notes rather than leaving bare numbers. A volume-based recipe and a mass-based scale display are not the same measurement. Follow the method and units specified in the chosen recipe; if adapting it to weighed water, record that adaptation clearly instead of silently treating the scale as a volume measurement. Keep one consistent system throughout your schedule.
Avoid resetting a cumulative reference
If a recipe gives cumulative targets on a scale, zero the prepared setup at the point specified by that recipe and keep that reference between pours. Resetting after each addition turns the display into a new partial amount. If a reset happens, use only amounts you actually recorded to reconstruct the total; otherwise note the uncertainty instead of inventing a precise result.
Make one clear note for the next brew
Before starting, write the total, the first wetting amount and whether later numbers are additions or cumulative targets. Check that all additions sum to the final total. After brewing, record any departure from the plan separately. The measured beverage in the cup is not automatically the same number as water poured through the coffee. Keep “water added” and “drink served” as separate entries.