Coffee scales: when to tare and what the reading means

By: ·

The same number on a coffee scale can describe beans, added water or an entire brewing setup. Its meaning depends on what is on the platform and when you last reset the display. Decide what you want to measure before brewing, rather than pressing tare whenever the number changes.

Start with the container

Put the scale on a flat, stable surface and switch it on as directed by its manual. Place your container on it, wait for a stable reading and tare. Beans added afterwards can then be weighed without the container. The Hario V60 Drip Scale manual describes this tare function. Removing the tared container may produce a negative reading; that alone does not mean the scale is faulty.

Record the coffee before resetting again

Suppose you weigh 18 g of beans. Write that down before grinding and taring again. If you weigh grounds in a filter, reset the setup before adding the coffee. These are different measurement points: your note should say whether the dose refers to beans before grinding or grounds actually placed in the filter. Keep that choice consistent when comparing two brews.

Check whether targets are cumulative

This is a reading example, not a recommended recipe: after taring the setup with the coffee, add 50 g of water, pour until the display reaches 150 g, then finish at 270 g. The individual additions are 50, 100 and 120 g. The total is 270 g, not 470 g. Do not tare between cumulative targets. If a recipe specifies separate additions instead, record each addition and add them together.

Notice what is sitting on the platform

With both the dripper and server on the scale, water moving between them remains within the weighed setup. With only a server on the scale beneath a separate stand, the display measures the beverage arriving in the server. These are different measurements. Lifting the dripper also changes the load, so record any reading you need before removing it.

Tare does not increase capacity

The container still counts towards the scale’s maximum load. Check your own model’s capacity and timer controls; buttons and modes vary. In your brewing note, record the coffee mass, total added water, tare points and equipment on the platform. This makes the measurement easier to repeat tomorrow. Use Crema’s free V60 recipe to practise the sequence while following the quantities in your chosen recipe.

Full free recipe →

Sources

Crema — V60 · Hario — V60 Drip Scale, manual · App Store